Frequently Asked Questions
These are the answers to the questions we get asked the most.
If you can’t find the answer to your question here, feel free to contact us
at [email protected]
What is Down the hole (DTH) drilling?
Drilling and blasting is important section during mining production.
Down the hole (DTH) drilling
Down-the-hole drilling is to drive the hammer behind the drill bit by compressed air via the drill pipe. The piston strikes the bit directly, while the hammer external cylinder gives straight and stable guidance of the drill bit. This makes the impact of energy is not lost in joints and allows for much deeper percussion drilling. Furthermore, the impact force acts on the rock at the bottom of the hole, which is more efficient, and straighter than other methods of the drilling operation. And DTH is more suitable for the big hole of hard rock drilling, special for rock hardness over 200Mpa. However, for the rock below 200 MPa, it will not only energy waste, but also in low drilling efficiency, and serious wear to the drill bit. It’s because while the piston of the hammer strike, the soft rock cannot absorb the impact completely, which seriously lower the efficiency of drilling and slagging.

Have more questions? Contact our sales to get the answers! CONTACT NOW!